16 and 25 station models

Sequential and Grouping

2 Independent Programs. A,B (Non over-lapping)

Permanent program memory

Filter Flushing Program (4 stations)

Chemical/Fertiliser Injection Program (2 cycle)

240 VAC or 12 VDC

12 VDC Solar power option using standard 24 VAC solenoids

Load and save facility for 7 complete file programs (i.e. Prog. A; Prog. B; Injection; Filter etc.)

Allows for easy seasonal recall Programming

14 Day Calendar with 9 Programming options per day

Station watering options 0-9999 seconds, 1 sec. increments 0-9999 minutes, 1 min. increments 0-9999 volume units, 1 unit increments

9 starts per day per program

Cyclic irrigation, 0-99 repeat cycles per each program start

Water Budget feature adjusts 0-250% per each program, 1% increments

Global Rain On/Off to disable all programs

Time Zone facility

To minimise operation costs for Off-Peak irrigation

Load and save facility for 7 complete file programs (i.e. Prog. A; Prog. B; Injection; Filter etc.)

Allows for easy seasonal recall

Inter Station Delay 0-250 secs

Pump off Delay 0-99 secs

Auto Skip Facility: A1: 0-250 secs at irrigation start to allow system to stabilize A2: Operational Scanning time/frequency (0-250 secs)

In group mode, the seven terminals allotted to chemical injection and filter flush can be used for irrigation valves if chemical injection/filter flush not used Operation

Manual Operations: Program Start; Station Start; and Time Set Station Start

Suspend and Restart during irrigation cycle

Manual station to station advance during irrigation cycle

Manual Stop Filter Flushing

Filter Flushing Program (4 Stations) with Time or Pressure Differential Starts Chemical Injection

2 Cycle Chemical or Fertiliser Program with pre-wet / pre-mix; delay and post wet capability

Chemical Injection can be suspended during filter flushing Inputs

Three flow meter inputs to log irrigation and two chemical flows

Sensor Inputs: Prog.?A start; Prog. B start; Reset; Hold; Auto Skip; PD Actuated (filters) Reports

Reports: Flow Totals as well as Irrigation or Electrical Failures with station skip

Reports totaliser for each irrigation and chemical station in volume or time

Separate flow records for chemical 1 and 2

Fault Reporting Monitors flow or pressure switches connected to the ASKIP terminal and utilises the auto skip programmable delay times Memory

Permanent program memory maintains all saved programs if power fails

No standby battery is required

9 volt Alkaline battery (included) keeps correct time during power failure (150 hours nomimal) Power Sources

240 VAC or 12 VDC in the one unit

12 VDC using 12 VDC solenoid coils

12 VDC Solar power option with inverter utilising standard 24 VAC solenoids Protection

Extensive Protection against field and mains power surges

Relay outputs to field valves ensures reliable operation under the most severe conditions

Isolated logic board protected by additional transformer which diverts surges to earth Communications/Software

Windows based* Software for PC applications

Allows for easy central location programming and fault reporting

RS232 and RS485 connections mounted on terminal strip

RS232 and RS485 ports can operate concurrently

Tipping rain bucket terminal

(For use with central control)

Radio Master ready

Compatible with Windows 98, 2000, ME, XP and Vista